Ford Focus 3 c346 2013, Manual

Page: 124 / 188

-124-
Topping up
WARNINGS
Only top up when the engine is
cold. If the engine is hot, wait 10
minutes for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Do not remove the filler cap when
the engine is hot. Wait for the
engine to cool down.
Undiluted coolant is flammable
and may ignite if spilt on a hot
exhaust.
Note: In an emergency, you can add
just water to the cooling system to
reach a vehicle service station. Have the
system checked by a properly trained
technician as soon as possible.
Note: Prolonged use of incorrect
dilution of the coolant can cause engine
damage from corrosion, overheating or
freezing.
Unscrew the cap
slowly
. Any pressure
will escape slowly as you unscrew the
cap.
Note: Do not top up further than the
MAX mark.
Top up with a 50/50 mixture of coolant
and water using fluid that meets the Ford
specification.
Customer assistance,
warranty and service guide ( page
25 ).
Maintenance
BRAKE AND CLUTCH FLUID
CHECK
WARNINGS
Do not allow the fluid to touch
your skin or eyes. If this happens,
rinse the affected areas immediately with
plenty of water and contact your doctor.
If the level is at the MIN mark,
have the system checked by a
properly trained technician as soon as
possible.
Use of any fluid other than the
recommended brake fluid may
reduce brake efficiency and not meet
Ford’s performance standards.
Note: Keep the brake fluid clean and
dry. Contamination with dirt, water,
petroleum products or other materials
may result in brake failure or costly
repairs.
Note: The brake and the clutch systems
are supplied from the same reservoir.
Top up with fluid that meets the
Ford specification. See
Customer
assistance, warranty and service
guide ( page 25 ).