Every Oil Change
Clutch
Lubricate the clutch release cross shaft and all
linkages.
Check the clutch fluid level.
Fuel System
Drain the accumulated water or sediment from
the fuel tank(s).
Steering System
Lubricate the steering shaft(s), U-joints and
splines if equipped with grease fittings.
Lubricate the front axle spindle pins.
Lubricate the steering linkage when equipped
with grease fittings.
Lubricate the power steering gear output shaft.
*
Make coolant protection checks just before the onset of freezing
weather, where applicable. If coolant is dirty or rusty in appearance,
drain the system, flush and refill the system with the prescribed solution
of cooling system fluid and distilled water. Use only permanent type
coolant that meets specifications as listed in your engine operator’s
manual. See the engine manufacturer’s operating guide for supplemental
corrosion inhibitor specifications.
Periodic Component and System Checks
The following are vehicle checks that should be made periodically either
by the owner or a qualified technician. Bring any deficiencies to the
attention of an authorized dealer or another qualified service outlet as
soon as possible to obtain advice about the need for service or
replacement.
Frequency
Recommended Action
At every engine start up.
Check ABS lamp operation.
After first 500 and 1000 miles (800
and 1600 km), then every 500 and
1000 mile (800 and 1600 km)
interval after tire removal or
replacement.
Tighten the wheel mounting nuts
to the specified torque. See
Technical specifications
in the
Wheels and Tires
chapter.
At least twice annually.
Clean body and door drain holes.
As required.
Clean windshield wiper blades.
Scheduled Maintenance
343
2015 F-650/750
(f67)
Owners Guide gf
(ownloose)
, 1st Printing, December 2013
Canadian_French
(fr_can)