3. Using both hands simultaneously
press and hold the hand-held
transmitter button and the desired
HomeLink
t
button. Do not release
the buttons until step 4 has been
completed.
Some entry gates and garage door
openers may require you to replace
step 3 with the procedure in the “Canadian Programing” section.
4. The red light will flash slowly and then rapidly. Release both buttons
when the red light flashes rapidly.
5. Follow steps 2 through 4 to program the remaining two buttons.
If you do not successfully program the HomeLink
t
Universal Transceiver
after repeated attempts, refer to
Rolling code programing
which
follows, or call toll-free customer assistance: 1–800–355–3515 or on the
Internet at
HomeLink.jci.com.
Operating the HomeLink
T
Universal Transceiver
Once programmed, the HomeLink
t
Universal Transceiver can be used in
place of hand-held transmitters. To
operate, simply press and release
the appropriate HomeLink
t
button
(the red light will illuminate,
indicating the signal is being
transmitted).
Rolling code programming
Rolling code garage door openers (or other rolling code devices) which
are “code protected” and manufactured after 1996, may be determined
by the following:
•
Reference the device owner’s manual for verification
•
The hand-held transmitter appears to program the HomeLink
t
Universal Transceiver but does not activate the device.
•
Press and hold the trained HomeLink
t
button. The device has the
rolling code feature if the indicator light flashes rapidly and then turns
solid after two seconds.
REC
DEL
PLAY
REC
DEL
PLAY
Controls and features
77
