Ford Content, Owner'S Manual, Page: 134 / 336

Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
t
to accept the signal
from the hand-held transmitter.
After completing steps 1 and 2
outlined in the
“Programming”
section, replace step 3 with the
following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•
Continue to press and hold the HomeLink
t
button (note step 3 in the
“Programming” section) while you press and release —
every two
seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
t
. The red indicator light
will flash slowly and then rapidly after HomeLink
t
accepts the radio
frequency signal.
•
Proceed with step 4 in the “Programming” section.
MESSAGE CENTER
With the ignition in the ON position,
the message center, located on your
instrument cluster, displays
important vehicle information
through a constant monitor of
vehicle systems.
You may select
display features on the message center for a display of status preceded
by a brief indicator chime. The system will also notify you of potential
vehicle problems with a display of system warnings followed by a long
indicator chime.
Driver Controls
134