•
When three quadrant lights are on and
the top left quadrant is off, the charge
is between 75–100 percent.
•
When all lights on the entire ring are
on, the charge is 100 percent.
Note:
When your vehicle is waiting to
charge, the light ring will turn off one minute
after displaying the present state of charge.
When your vehicle automatically begins
charging, the light ring will turn on and
display how far along the charge is per the
section above.
Note:
If the system detects a vehicle
charging system fault at any point in a
charge cycle, the entire light ring will flash
continuously for one minute and then turn
off. If this happens, unplug the charging
coupler and then plug it back into the charge
port receptacle. If the problem persists,
contact an authorized dealer.
You can modify the lighting ring. See
Charge Port Light Ring Settings in the
MyFord Touch section. See
MyFord
Touch™
(page 352).
Disconnecting the Charging Coupler
Note:
Do not pull the wall plug from the
wall while your vehicle is charging. Doing so
may damage the outlet and the cord.
1.
Remove the lock from the charging
coupler button.
2. Press the button on the charging
coupler.
3. While holding the button, remove the
charging coupler from the charge port
receptacle on your vehicle.
E144781
4. Close the charge port door by pressing
the indentation on the charge port
door. Continue pressing the indentation
while the door rotates
counterclockwise and closes.
HIGH VOLTAGE BATTERY CUT-
OFF SWITCH
The high-voltage shut off operation shuts
off power from the high-voltage battery
after a collision, or if your vehicle receives
a substantial physical jolt.
To reactivate the vehicle after either event
perform the following steps:
1.
Turn the ignition off.
2. Turn the ignition on.
3. If the vehicle is not powered after this
sequence, repeat steps 1 and 2.
For vehicles equipped with a push button
start system:
1.
Press the
START/STOP
button to
turn ignition off.
2. Press the brake pedal and press the
START/STOP
button.
3. Remove your foot from the brake pedal
and press the
START/STOP
button
(ignition off).
4. Press the
START/STOP
button again
to re-enable the vehicle.
164
Fusion/Mondeo (CC7)
High Voltage Battery
Summary of Contents for 2014 FUSION ENERGI
