2. Press and hold the RESET
control for 2 seconds and release.
Oil life is set to 100% and “OIL LIFE
SET TO 100%” is displayed.
FOR 4X4 LOW STOP VEHICLE (if equipped).
Displayed when 4X4
LOW is selected while the vehicle is moving. For more information, refer
to
Control trac four-wheel drive (4x4) operation
in the
Driving
chapter.
FOR 4X4 LOW SHIFT TO N (if equipped).
Displayed when 4X4 LOW
is selected and the vehicle is stopped. For more information, refer to
Control trac four-wheel drive (4x4) operation
in the
Driving
chapter.
TO EXIT 4X4 LOW STOP VEHICLE (if equipped).
Displayed when
2WD is selected while the vehicle is operating in 4X4 LOW. For more
information, refer to
Control trac four-wheel drive (4x4) operation
in
the
Driving
chapter.
TO EXIT 4X4 LOW SHIFT TO N (if equipped).
Displayed when 2WD
is selected while the vehicle has been stopped in 4X4 LOW. For more
information, refer to
Control trac four-wheel drive (4x4) operation
in
the
Driving
chapter.
POSITIVE RETENTION FLOOR MAT (IF EQUIPPED)
Do not install additional floor mats on top of the factory installed
floor mats as they may interfere with the accelerator or the
brake pedals.
Position the floor mat so that the
eyelet is over the pointed end of the
retention post and rotate forward to
lock in. Make sure that the mat does
not interfere with the operation of
the accelerator or the brake pedal.
To remove the floor mat, reverse the
installation procedure.
2008 Expedition
(exd)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
145
