To reprogram the remote entry
transmitters:
1. Ensure the vehicle is
electronically unlocked.
2. Put the key in the ignition.
3. Turn the key from the 1 (LOCK)
position to 3 (RUN).
4. Cycle eight times rapidly (within
10 seconds) between the 1 (LOCK)
position and 3 (RUN).
Note:
The
eighth turn must end in the 3 (RUN) position.
5. The doors will lock, then unlock, to confirm that the programming
mode has been activated.
6. Within 20 seconds press any button on the remote entry transmitter.
Note:
If more than 20 seconds have passed you will need to start the
procedure over again.
7. The doors will lock, then unlock, to confirm that this remote entry
transmitter has been programmed.
8. Repeat Step 6 to program each additional remote entry transmitter.
9. Turn the ignition to the 1 (LOCK) position after you have finished
programming all of the remote entry transmitters.
10. The doors will lock, then unlock, to confirm that the programming
mode has been exited.
Illuminated entry
The interior lamps illuminate when the remote entry system is used to
unlock the door(s).
The illuminated entry system will turn off the interior lights if:
•
the ignition switch is turned to the 2 (ACCESSORY) position, or
•
the remote transmitter lock control is pressed, or
•
the doors are locked by key in the door cylinder, or
•
after 25 seconds of illumination.
Illuminated exit
•
The interior lights will illuminate when the key is removed from the
ignition.
The lamps automatically turn off after 25 seconds. The dome and cargo
lamp controls must
not
be set to the OFF position for the illuminated
exit system to operate.
2006 Escape Hybrid
(hev)
Owners Guide (post-2002-fmt)
USA
(fus)
Locks and Security
115
Summary of Contents for 2006 Escape Hybrid
Page 296: ...Maintenance and Specifications 296...
Page 328: ...328...
