Ford 2002 Bantam, Workshop Manual, Page: 1340 / 1663

417-01-22 Exterior Lighting 417-01-22
DIAGNOSIS AND TESTING ( CONTINUED )
CONDITIONS DETAILS/RESULTS/ACTIONS
F3: CHECK THE RELAY – LOW BEAM F R PROPER FUNCTION O
1 . 2 .
Relay – low beam
C6
3 .
• Are the low beam headlamps on continuously?
Yes
GO TO F5
No
GO TO F4
F4: CHECK THE CONTROL CIRCUIT OF RELAY – LOW BEAM FOR SHORT TO POWER
1 Measure the voltage between multifunction
switch, connector C15a, pin 1, circuit 14S-
LE19 (VT/BU), harness side and ground.
• Is battery voltage indicated?
Yes
REPAIR the short to power, circuit(s)
connected with the multifunction switch,
connector C15a, pin 1, by using the wiring
diagrams. TEST the system for normal
operation.
No
INSTALL a new relay – low beam. TEST the
system for normal operation.
F5: CHECK THE CIRCUI TO LEFT-HAN LOW BEAM HEADLAMP FOR SHORT TO POWER T D
1 . 2 .
Fuse F10 (10 A)
(CJB)
3 .
4 Check if the left-hand low beam headlamp is
on continuously.
• Is the left-hand low beam headlamp on
continuously?
Yes
REPAIR the short to power, circuit(s)
connected with the headlamp, left-hand
side, connector C45, pin 2, by using the
wiring diagrams. TEST the system for
normal operation.
No
GO TO F6
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL