Ford 2002 Bantam, Workshop Manual, Page: 1341 / 1663

417-01-23 Exterior Lighting 417-01-23
DIAGNOSIS AND TESTING ( CONTINUED )
CONDITIONS DETAILS/RESULTS/ACTIONS
F6: CHECK THE CIRCUI TO RIGHT-HA D LOW BEAM HEADLAMP FOR SHORT TO POWER T N
1 . 2 .
Fuse F11 (10 A)
(CJB)
3 .
4 Check if the right-hand low beam headlamp is
on continuously.
• Is the right-hand low beam headlamp on
continuously?
Yes
REPAIR the short to power, circuit(s)
connected with the headlamp, right-hand
side, connector C46, pin 2, by using the
wiring diagrams. TEST the system for
normal operation.
No
REPAIR the short to power, circuit(s) con-
nected with the relay – low beam, connector
C6, pin 3, by using the wiring diagrams.
TEST the system for normal operation.
F7: CHECK THE MULTIFUNCTION SWITCH FOR PROPER FUNCTION
1 . 2 .
Multifunction switch
C15a
3 .
• Are the high beam headlamps on
continuously?
Yes
GO TO F8
No
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
F8: CHECK RELAY – HIGH BEAM FOR PROPER FUNCTION
1 . 2 .
Relay – high beam
C5
3 .
• Are the high beam headlamps on
continuously?
Yes
GO TO F10
No
GO TO F9
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL