Ford 2002 Bantam, Workshop Manual

Page: 1339 / 1663

417-01-21 Exterior Lighting 417-01-21
DIAGNOSIS AND TESTING ( CONTINUED )
CONDITIONS DETAILS/RESULTS/ACTIONS
E9: CHECK THE POWER SUPPLY OF FUSE F22
1 Measure the voltage between fuse F22 (10 A)
(CJB) and ground.
• Is battery voltage indicated?
Yes
REPAIR the open circuit(s) between fuse
F22 and headlamp, right-hand side, by
using the wiring diagrams. TEST the system
for normal operation.
No
REPAIR the open circuit(s) between relay –
high beam and fuse F22, by using the wiring
diagrams. TEST the system for normal op-
eration.
PINPOINT TEST F: THE HEADLAMPS ARE ON CONTINUOUSLY
CONDITIONS DETAILS/RESULTS/ACTIONS
F1: CHECK THE HEADLAMPS
1 .
2 Check whether the high and low beam
headlamps are on continuously.
• Are the high and low beam headlamps on
continuously?
Yes
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
No
Low beam headlamps are on continuously:
GO TO
F2
High beam headlamps are on continuously:
GO TO F7
F2: CHECK THE MULTIFUNCTION SWITCH FOR PROPER FUNCTION
1 . 2 .
Multifunction switch
C15a
3 .
• Are the low beam headlamps on continuously?
Yes
GO TO F3
No
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL