414-03B-57
414-03B-57
High Voltage/Traction Battery — Nickel Metal Hydride
DIAGNOSIS AND TESTING (Continued)
PINPOINT TEST P: IOM TO BCM DIAGNOSTIC INPUT STUCK HIGH FAULT
TEST STEP
ACTION TO TAKE
— pins 37 and 16
•
Are the resistances greater than 10,000 ohms?
P7 CHECK SIGNAL WIRES TO IOM BATTERY TEMPERATURE
SENSORS FOR SHORT(S) TO POWER
•
With key ON, measure the voltage between the pins on IOM C1810
Yes =
REPAIR the wire(s) in
indicated below for the IOM battery temperature sensor signal wires:
question.
No =
GO to P8.
IOM Battery Temperature Sensor #1 (LB wire)
— pins 35 and 16
IOM Battery Temperature Sensor #2 (LG wire)
— pins 36 and 16
IOM Battery Temperature Sensor #3 (P wire)
— pins 37 and 16
•
Are any of the voltages greater than 0 volts?
P8 CHECK IOM BATTERY TEMPERATURE SENSORS
•
With key OFF, measure the resistance between the terminals of the IOM
Yes =
GO to P9.
battery temperature sensors.
•
Are the resistances between 430 and 280,000 ohms?
No =
REPLACE the IOM battery
temperature sensor(s) in
question.
P9 CHECK ON-PLUG DETECT CIRCUIT 3404 (Y) FOR OPEN
•
Connect 104-Pin Breakout Box (BOB) to BCM C1986, C1987 using the
Yes =
GO to P10.
BCM/TIM BOB Adapter Cable and Overlay; leave the BCM
disconnected.
•
With key OFF, measure the resistance of the Y wire between pin 30 on
No =
REPAIR the Y wire.
IOM C1810 and BOB pin B12.
•
Is the resistance less than 5 ohms?
P10 CHECK IOM TO BCM DIAGNOSTIC INPUT CIRCUIT 4008
(R/BK) FOR OPEN
•
With key OFF, measure the resistance of the R/BK wire between pin 32
Yes =
GO to P11.
on IOM C1810 and BOB pin A36.
•
Is the resistance less than 5 ohms?
No =
REPAIR the R/BK wire.
P11 CHECK BCM TO IOM DIAGNOSTIC OUTPUT CIRCUIT 4007
(Y/LG) FOR SHORT TO GROUND
•
With key OFF, measure the resistance between BOB pin B11 and ground Yes =
GO to P12.
(BOB pin A33).
•
Is the resistance greater than 10,000 ohms?
No =
REPAIR the Y/LG wire.
P12 CHECK IOM TO BCM DIAGNOSTIC INPUT CIRCUIT 4008
(R/BK) FOR SHORT TO POWER
•
With key ON, measure the voltage between BOB pin A36 and ground
Yes =
REPAIR the R/BK wire.
(BOB pin A33).
•
Is the voltage greater than 0 volts?
No =
REPLACE the IOM.
P13 CHECK BATTERY TEMPERATURES AFTER STOP OF
CHARGING
(Continued)
2001 Ranger EV, 01/2001
Summary of Contents for 2001 Ranger
