Force SPARC/CPCI-520G, Technical Reference Manual

Page: 25 / 134

Installation
SPARC/CPCI-52x(G) Page 11
3 Installation
This section describes the SPARC/CPCI-52x(G) variants you may pur-
chase from FORCE COMPUTERS. It is intended to get an overview over
all possible configurations with named components which will help to
find the information necessary for your configuration in this manual.
How to begin
installation First read the Safety Notes and the Installation Prerequisites and Require-
ments (see section 1 “Safety Notes” on page 1 and section 3.1 “Installa-
tion Prerequisites and Requirements” on page 14).
Then go through the Base-520(G) installation section and the I/O-52x(G)
installation section, depending on the variant you have purchased from
FORCE COMPUTERS (see section 4 “Base-520(G) Installation” on
page 21 and see section 5 “I/O-52x(G) Installation” on page 53).
SPARC/
CPCI-52x(G)
variants There are 4 variants available:
• a SPARC/CPCI-520G
obtaining the 2 slot high base board with UPA64S card option named
in this manual as Base-520G (or in general as Base-520(G)).
Figure 1 SPARC/CPCI-520G (schematic view)
• a SPARC/CPCI-522
obtaining the 1 slot Base-520 with the peripheral slot I/O-522.
Figure 2 SPARC/CPCI-522 (schematic view)
SCSI SERIAL A + B SERIAL A + B
Ethernet
MIC SPK
LED
MODE DIAG
RST HLT
UPA 64S
KBD
local PCI local PCI
UPA 64S UPA 64S
Base-520G
1 CompactPCI
segment
SCSI SERIAL A + B SERIAL A + B
Ethernet
MIC SPK
LED
MODE DIAG
RST HLT
KBD
local PCI
UPA 64S
PMC Card PMC Card
UPA 64S
PMC
Ethernet
PMC
Ethernet
PMC # 2 PMC # 1
1 CompactPCI
segment
Base-520
I/O-522