Product Specifications:
Includes: 1 x Scoot Cosmo hand operated drone, 1 x Built-in 3.7V 380 mAh
Li-Po rechargeable battery, 1 x USB charging cable, and 1 x Instructions
Manual
Flight Time: 5 Minutes | Charge Time: 60 Minutes
Drone Dimensions: 4.5” D x 2” H | Drone Weight: 1.6 Oz
Flight Directions:
1. Do not fly in strong wind or light.
2. Do not fly in narrow spaces.
3. Always fly with fully charged batteries for optimum drone performance.
4. Do not fly damaged drones.
5. In the event of a crash, place the drone on a flat surface and allow it 2-3
seconds to reorient itself before flying again.
Lithium Battery Charging Instructions:
1. Plug the USB charging cable into the USB port with a 5V output and charging
current of 1-2a.
2. Charge with a computer, laptop, car charger, cell phone charger, or power
bank.
3. Charging light indicator will blink while charging.
4. Max charge time is 60 minutes. Do not overcharge the drone battery.
Battery Safety Warnings:
Do not charge the battery unattended. Adult supervision is highly recom-
mended.
Do not put the battery next to flammable or explosive materials.
Stop charging the battery when it gets deformed, discolored, becomes too
hot, or if other abnormal phenomena occur.
If the battery leaks, avoid contact with the skin and eyes. If battery leak comes
in contact with eyes or skin, immediately rinse with clean water and consult a
doctor.
Do not put the battery in a fire, microwave, pressure tank, and the like.
Do not use solvents, industrial alcohol, or other flammable solvents to clean
the product and the charger.
The product contains plastics, electronic components, and a battery. Please
do not treat it as regular trash. Sort and dispose according to the local waste
recycling regulations.
Flight Preparations:
1. Turn on the switch to start. The LED light indicator will flash for a few
seconds, indicating that the drone is ready to fly. Place the drone on a flight
surface for a small stable launch.
2. Put the drone on your palm then gently toss into the air to launch. The LEDs
will flash when taking off.
3. Motion sensor detectors around the drone will detect your hand and other
“obstacles” then fly towards the opposite direction.
4. The LEDs will blink slowly to indicate low battery charge.
5. To stop the drone from flying, gently catch it “hamburger-style” then turn it
upside down to turn off the motor.
Calibration Instructions:
1. Turn off the drone then turn on again.
2. The center light will flash from red to green. When the center light turns
solid green, shake the drone back and forth 3 - 5 times.
3. After shaking, the center light will flash from red to green, indicating that
the drone is in calibration mode.
4. Place the drone on a flat surface while it calibrates.
5. Calibration is complete when the center light turns solid green.
Sensor
Sensor
Sensor
Power Switch
Sensor
Sensor
Charging Port
Receiver
