11
Installation of
Water Supply Connector
Make sure that you hook up to the cold water tap. Determine the location for the installation of
the RO system. Avoid locations where the system might come in contact with hot water pipes
or other hazards like sunlight.
The water supply connector comes with the Forbes Under Sink RO unit in the installation kit.
1)
Disconnect the water supply
line from the cold water tap,
attach and tighten water supply
connector assembly.
2)
If you install above the sink,
then remove your existing
overhead water tank top, attach
and tighten water supply
connector assembly.
NOTE:
Use an insert when connecting the tube to the faucet.
Mounting the Product Water Faucet
Your Forbes Under Sink RO unit comes complete with a long reach faucet.
The product water faucet may be installed on any flat surface at least 2
inches in diameter. Check the inside of the location for interference.
Faucet mounting bracket is provided in the installation kit. This can be
mounted on any wall. Install the mounting bracket on wall, then mount the
faucet.
1) Slide the chrome cover plate and rubber gasket on to the stem of the
faucet and place faucet on to the sink/mounting bracket on wall, then
mount the faucet. For mounting on sink, you may need to drill a hole.
2) Place metal washer and lock washer over threaded stem of faucet and
tighten nut from under the counter surface to lock the faucet into place. DO
NOT OVERTIGHTEN.
3) Connect the tube to the faucet stem under the count/faucet bracket.
