Forbes Marshall Aquacon 4000, Instruction Manual, Page: 37 / 59

Instruction Manual Aquacon 4000
32
6.8 Wash relay (WASH) sub-function
In this sub-function you set the parameters for the wash relay.
SETUP
SETUP
HOLD HOLD
4 4
ENT
SETUP SETUP SETUP
HOLD HOLD HOLD
4 4 4
ENT
ENT ENT ENT ENT
SETUP SETUP
HOLD
HOLD
4 4
1. Select the “WASH” sub-function, then press the ENT key .
2. Enabling/disabling wash function: press the ▲ or ▼ key to enable (WASH ON) or
disable (WASH OFF) wash function. Press the ENT key to confirm your selection.
3. Selecting the relay status condition: press the
▲
or
▼
key to choose desired relay
status (de-energized = “DEEN” or energized = “EN”). Press the ENT key to confirm your
selection.
4. Setting the wash interval in hours: Press the ▲ or ▼ key to set the desired wash
interval (setting range: 0.1 to 199.9 hours). Press the ENT key to confirm your setting.
5. Setting the wash duration in seconds: Press the
▲
or
▼
key to set the desired wash
duration (setting range: 1 to 1999 seconds). Press the ENT key to confirm your setting.
Note : During wash cycle the transmitter is set to HOLD. For safety reasons, the
HOLD function is activated 5 seconds prior and deactivated 10 seconds after the
wash cycle.
Continue with Setup mode procedures, or return to Measurement mode by pressing the
▲
and
▼
keys simultaneously (escape).