6: Roll the ball up onto
the support ring, taking
care not to nip the pipe
(two people are needed to
place the 40cm ball).
Adjust the ball so the hole
is in the middle, this will
allowing the water to flow
evenly over the ball.
Cont:-
Note.
Ensure the ball is the
right way up with the
30mm recess hole at
the top see Diagram
B
and Picture
B1
.
3 : First ensure that the ball is the correct way up with the
30mm recess hole at the top. See picture
B1
. Then roll the
ball up to the edge of the ring and secure in position so it
does not move.
5: Feed the water pipe up from the reservoir through the bottom of the
ball. Connect the water pipe to the luminar Nozzle.
4: Begin to feed the luminar plug and cable (shown in red) down through the ball, then down through the
support ring into the reservoir. Pull any slack down and store in reservoir, then run the luminar plug up and
over the lip of the reservoir and through underground pipe (if installed) to the required power supply. Leave
the luminar Nozzle a few inches from the ball recess. See Diagram
B
.
Picture
B1
. Ball
top
Cont:-
B
