EN-14
1. To initiate transmission
(a) The meter starts the transmission automatically after each
measurement, sending the new data and previous data that
has not been sent.
(b) With the meter turned on, press Sync to initiate
transmission for test results that have not been uploaded.
2. During transmission
When the arrow symbol shows up, the data transmission
has started. The message “Upload OK” will appear when the
transmission is finished.
Note:
• If using the device for the first time, the “---” icon will appear
when you recall the test results or review the average result. This
indicates that there is no test result in the memory.
• Control solution results are NOT included in the day average.
Transferring Data
Data Transmission via Mobile Network
The meter could upload test results to a data system through a
mobile network if your healthcare provider needs to collect the
data remotely. Usually, the settings and the SIM card deployment
should have already been placed in the meter when you receive
it. The test results will be uploaded right after every measurement
without a manual transmission. The data will be encrypted during
transmission and only the service provider can decipher it. No
personal identity will be revealed in the transmission payload.
Following the instructions of your care service provider should
enable you to get connected with the service contact. When you
use the meter for the very first time, it’s highly recommended that
you contact your service provider to confirm that the transmission
to your account at the server side is correct and successful.
To learn more about the service procedure or transmission,
please contact the customer service of your service provider. Data
transmission is an optional function that depends on your service
provider. You may perform measurements without this function.
