FOR-A MV-1600, Operation Manual

Page: 41 / 88

33
Setting Items
Item Setting Description
(1) SWITCH
LOCK
Disable or enable buttons on the front panel
OFF: Activates buttons.
ON: Deactivates buttons except the MENU button.
If any front panel button except MENU button is pressed while
buttons are deactivated, the MENU button flashes to indicate that
the Switch Lock is on.
Operation mode setting
SXGA
The SXGA output is enabled. The video transfer is
also enabled. However, due to the priority on the
SXGA output, the frame rates (refresh interval) of
video transfer over the LAN interface is reduced.
NETWORK
The video transfer over the LAN interface is
enabled.
A The video transfer over the LAN interface with
alarm/video loss information is enabled.
SXGA&
NETWORK
Both the SXGA output and the video transfer over
the LAN interface are enabled. However, the frame
rates of both functions become lower than those of
when using either one alone.
(2) FUNCTION
SXGA&
A
Concurrent use of the SXGA output and the video
transfer over the LAN interface with the alarm/video
loss information is enabled.
(3) REMOTE /
ALARM
Sets the connector on the rear panel to REMOTE control or ALARM
input.
REMOTE: Enables the remote control of the MV-1600.
ALARM: Enables to receive external alarm inputs.
* CH1 to CH16 of REMOTE receive alarm signals.
Network mode setting
UNICAST
Sets to the unicast mode.
(4) NETWORK
MODE
MULTICAST Sets to the multicast mode.
(5) ID
Sets the ID for the connection with Web browser and the dedicated
software. Set with up to 8 alphanumeric characters. If all 8 characters
are set with the space character, the authentication is not performed.
(6) PASSWORD
Sets Password for the connection with Web browser and the
dedicated software. Set with 5-digit numbers.
(7) FAN
Displays the fan status.
OK: The fan is operating without problem.
NG: An error has occurred in the fan.
(8) SOFTWARE
VERSION
Displays the internal software version,.
(9) HARDWARE
VERSION
Displays the internal hardware version.
IMPORTANT
To stop transmitting video, set the frame rate to "0". See the appendix MV-1600
RS-232C/LAN Command, section 2-7, "Video Transmission Frame Rate Commands"
for details.
The ID and PASSWORD settings are applied when the power to the MV-1600 is turned
on. If the settings are changed, be sure to turn off the MV-1600 and then turn it on again
to apply the settings.