FONON SBM Series, User Manual

Page: 56 / 86

Chap ter 3 Operation
61

Color Setup
The settings of each color can be adjusted under this selection after the file has
been sent. This is useful when testing parameters.

Setting Pen
Indicates the color you want to modify.

Power
Indicates the present power for setting pen. Its range is between 0~100%.

Speed
Indicates the present speed for setting pen. Its range is between 0~100%.

PPI
Indicates the number of pulses per inch for setting pen. It has six options,
and they are 166, 200, 250, 333, 500, and 1000.

Color Control
There are two options: [by file] and [by panel ]. [by file] means that the color
settings are defined based on print driver
for single file. [by panel ] means that
the color settings are defined based on [Color Setup ] for all files.

Lase r Tickle Setup
The laser tickle pre-ionizes the gas into a plasma state so that it is just below the
lase threshold. Increasing tickle width beyond 1 μ s will add enough energy to
the plasma to cause laser emission. By applying a laser tickle, the laser will
respond predictably to laser signal even when there is considerable “off” time
between applied pulses
. It is recommended NOT to change the settings unless
instructed to by a Fonon technician.

Alignment Mode
This function is used for alignment of laser. It is recommended NOT to use this
function unless instructed to by a Fonon technician.

Tickle output
Indicates the power for laser tickle. Its range is between 0~100%.

Continuous
If this function is on and press , the laser tickle will emit continuously
until pressing again. If this function is off, the laser tickle emits only
when you keep pressing .

Fast move
If this function is on, you can move the carriage faster to nine position of
working table by using motion control keys.