CONNECTION AND OPERATING
- Make the connections with the amplifier and all components of the audio system switched off and
disconnected from the mains supply.
- Connect the audio equipment or microphones required to the corresponding inputs. If you wish, connect
the USB storage device or the SD memory card in the appropriate inputs.
- Check that the volume controls VOL 1 and VOL 2 and the auxiliary input volume controls are set at their
minimum.
- Check that the BASS and TREBLE controls are set at medium level.
- Connect the loudspeakers to the low impedance outputs 4-16 Ω in a series/parallel circuit so that the load
impedance of the loudspeakers is the same as the amplifier output impedance and that the power supplied
by the amplifier does not exceed that withstood by the loudspeakers.
- Power the device using the AC power socket.
- Once the connections have been made according to your needs, connect the devices to the power supply
and switch them on. After use, do not forget to switch off and disconnect the device from the power supply.
- 7 -
EN
WA-4100_MANUAL_(EN)_20180215_Maquetación 1 15/2/18 8:43 Página 7
