EN
- 6 -
CONNECTION AND OPERATING
DIRECT CONNECTION WITH CAT 5e/6 CABLE
- Connect the AV digital source to the transmitter INPUT using the HDMI cable.
- Connect the receiver OUTPUT to the television using the HDMI cable.
- Use cable Cat 5e/6 up to 120 m to connect the transmitter and the receiver with cable according to the
IEEE-568B standard.
- Power the transmitter and the receiver of the
FO-455M
with the mains adapters provided.
- Switch on the A/V digital source and the television.
Note
: select the same channel in the receiver as in the transmitter.
CONNECTION VIA TCP/IP ETHERNET
- Connect the A/V digital source to the transmitter INPUT using the HDMI cable.
- Connect the receiver OUTPUT to the television using the HDMI cable.
- Connect the transmitter output to the switch input using the Cat 5e/6 cable according to standard
IEEE-568B.
- Use the Cat 5e/6 cable up to 120 m to connect the switch and the receiver with cable according to
IEEE-568B standard.
- Power the transmitters
FO-455M
and the receivers
FO-456MR
with the mains adapters provided.
- Switch on the A/V digital source and the televisions.
Note
: this configuration allows the connection of up to 16 transmitters and 237 receivers. Select in each
receiver the channel corresponding to the transmitter with the audio/video source required.
INSTRUCTIONS FOR USE
The transmitters and the receivers come with the IP and MAC default addresses assigned, as follows:
To assign or change the IP and MAC addresses of the transmitters and receivers take the following
instructions into consideration:
1.-
CHANGE THE COMPUTER’S IP ADDRESS
In order to make any changes to the IP and MAC addresses of mods.
FO-455M
and
FO-456MR
, it is
neccessary to assign the computer an IP address within the same range as the devices in the installation.
Follow the steps below:
160311_FO-455M_FO-456MR_MANUAL_(EN)_Maquetación 1 14/3/16 8:31 Página 6
