CONNECTION
- Before making any connections make sure that all the equipment is switched off. Check that the volume
controls CH A and CH B are at their minimum.
- The loudspeakers must be connected in a series/parallel circuit so that the charge impedance of the
loudspeakers is the same as the power amp output charge impedance and that the power supplied by the
power amp does not exceed that withstood by the loudspeakers.
- Once the connections have been made according to your needs, connect the equipment to the mains and
switch it on. After use, do not forget to switch the equipment off and disconnect it from the mains.
STEREO MODE
Place the MODE selector on the back of the power amp in the STEREO position. In this mode, the two
channels operate independently. Connect the two inputs and the two loudspeaker outputs. The channel
volume is adjusted separately.
- 5 -
EN
160718_DSA-300_MANUAL_(EN)_Maquetación 1 18/8/16 13:34 Página 5
