FONESTAR ASB-10120U, Instruction Manual

Page: 4 / 20

EN
- 4 -
CONNECTION
- Before turning on the power, make sure that the volume controls are set to minimum and the POWER
switch is turned off.
- Connect the power cord of the equipment to the power outlet.
- Connect a line level signal, coming from the output of a mixer, CD player, etc., to the LINE INPUT of the
speaker. You can also connect a USB storage device or SD memory card to the corresponding ports.
- If desired, a dynamic microphone can be connected to the MIC INPUT.
- Turn on the speaker with the POWER switch on the rear panel.
- Adjust the volume of the inputs to the desired level with the corresponding controls.
- The speaker output provides a line level (LINE OUT output) for input to another amplified loudspeaker,
mixer, amplifier, recorder, etc.
- In addition, you can connect a passive speaker to the SPEAKER OUTPUT terminal, if desired.
- When the equipment is not in use, turn it off: turn the volume controls to minimum, turn it off with the
POWER switch and disconnect the power supply from the mains socket.
ASB-880U ASB+10120U
MP3 VOL
MIC
INPUT
LINE OUT
LINE INPUT
MIC VOL
LINE VOL
TREBLE
BASS
CLIP POWER
POWER CONSUMPTION: 120 W
SPEAKER OUTPUT
8 Ω
~115 V AC. 50/60 Hz FUSE 2 A
MASTER
SB-3608
AMP
PLAYER
CLIP POWER
SB-3611
AMP
PLAYER
WIRELESS CONNECTION OF 2 SPEAKERS
This speaker can be connected wirelessly to another speaker in from the same series by following the steps
described below:
1.- Turn on both speakers and select wireless mode.
2.- Long press the PLAY/PAUSE button until you hear a beep. This speaker will be the MASTER
speaker and will play the left channel (L) of the stereo signal.
The other speaker will be the secondary speaker (SLAVE) and will play the right channel (R) of the
stereo signal.
3.- Connect your wireless audio device to the MASTER speaker and you will hear another beep
indicating that it has been successfully connected.