Fonax FNX-HL, User Manual

Page: 6 / 8

Connect the handset and main phone case with the phone cord.
Connect the LAN port of the phone to the RJ-45 socket of a hub/switch
or a router (LAN side of the router) using the Ethernet cable.
Connect the 5V DC output plug to the power jack on the phone; plug
the power adapter into an electrical outlet.
The LCD will display provisioning or firmware upgrade information.
Before continuing, please wait for the date/time display to show up.
Using the phone embedded web server or keypad configuration
menu, you can further configure the phone using either a static IP or
DHCP.
Attach the two wall mount spacers to the slot for wall mount spacers on
the back of the phone.
Attach the phone to the wall via the wall mount hole.
Pull out the tab on from the handset cradle (See figure below).
Rotate the tab and plug it back into the slot with the extension up to
hold the handset while the phone is mounted on the wall (See figure
below).
Installing the Phone (Wall Mount)
PHONE SETUP
For installing the phone on the table with the phone stand, attach the phone
stand to the bottom of the phone where there is a slot for the phone stand
(upper part, bottom part).
To setup the FNX-HL, follow the steps below
CONNECTING THE PHONE
Installing the Phone (Phone Stand)
Slot for the phone
stand if placing the
phone on the table
Slot for the wall
mount spacers if
placing the phone
on the wall
Wall mount holes
are available
5
4
3
2
1
4
3
2
1
Tab with extension up
Handset Rest
Tab with extension down
PC Port
LAN Port
Power
Headset Port
Handset Port