5
5. Specifications
6. Using your flash head
1.
The light intensity, power output and all other settings are set to minimum levels. These are the factory
default settings .
2.
Before you switch the flash on, check the light intensity of the modelling lamp and flash.
3.
Connect the synchro cable to the synchro connector.
4.
Switch the equipment on. The blue control light comes on.
5.
Never forget to discharge the residual voltage before switching the flash off.
7. Maintenance
1.
How to change the modelling lamp
- Before changing the lamp, let the equipment cool down.
- Be careful not to leave dirt or fingerprints on the lamp. After lamp replacement, clean the lamp with
soft and dry cloth.
2.
How to change the fuse
- First, disconnect the AC input cord.
- Open the fuse cover and remove the fuse.
- Check the fuse and if it is broken, replace with a new one.
3. Flash
maintenance
- During storage, keep the flash lamp free from dust and dirt.
- Dirt and grease on the reflector and on the flash lamp will shorten their operating life. Dirt decreases
the colour temperature of the emitted light. Clean with a soft, dry cloth.
* Notes: If the voltage in the wall outlet is lower than the required voltage, full recharge may not be possible.
Check the wall outlet voltage before connecting the equipment. The manufacturer reserves the right
to change the specification of the product, without previous notice whatsoever.
Model
Digitalis 600
Digitalis 400
Digitalis 200
Lamp output /Ws/
600
400
200
Flash charge/s/
0.1 – 2.2
0.1 – 1.9
0.1 – 1.7
Flash length/s/
1/1700
1/2300
1/4000
Flash colour temperature/K/
5600
5610
5580
Test bulb output /W/
100
100
100
Test lamp colour temperature
3200
3200
3200
Dimensions
38.5 x 11.5 x 12
38.5 x 11.5 x 12
38.5 x 11.5 x 12
Weight
2.7
2.5
2.3
Order number
FY7772
FY7771
FY7770
