FOM INDUSTRIE SIKA PLUS XZ-10567, Use And Maintenance Manual Spares Catalogue, Page: 60 / 182

52
GB
SIKA PLUS
9.2 OPERATING - SIKA PLUS AUTOMATIC
The machine has a hydraulic blade down feed, while the vices and the atomised cutting lubrication are pneumatic.
Check:
-
that the power supply voltage is the same as that of the machine.
- the blade rotation direction.
After adjusting the position of the vices in relation to the profile to be cut, position the profile on the work table clamping
it with the vices.
CAUTION:
Check carefully that the vices are not within the working range of the blade.
When button "A" - Fig. 09-02 is pressed, the profile is clamped with the vices in LOW PRESSURE.
If the profile is not correctly positioned, the vices can be re-opened by pressing button "B" - Fig. 09-02.
When the profile is correctly positioned, turn the main switch to
I.
By pressing simultaneously (and keeping pressed down) the CUT buttons "A" and "C" - Fig. 09-02, the head comes
down, atomisation and the vices HIGH PRESSURE are enabled.
If one or both of the CUT buttons are released, cutting is interrupted as the head returns upwards.
The sawing operation then takes place.
Once cutting is finished both the CUT buttons "A" and "C" - Fig. 09-02 can be released and the head returns upwards.
The vices re-open by pressing button "B" - Fig. 09-02.
09-02
A
B
C