ca 30 mm
Mounting and instructions for use
Wall with protruding/indented elements:
Mounting the ladder with a 10 cm to 40 cm distance
from the wall:
Use telescopic/adjustable brackets. The
brackets come in these sizes: 10 cm - 15 cm, 15 cm – 23
cm or 24 cm – 40 cm.
Mounting the ladde
r
with a distance less than
6 cm
from the
wall
:
Use extension brackets
.
These come in 2 cm and 3,2 cm and can be used together..
This method can give the ladder a distance of appr. 6 cm. Use telescopic
brackets to give the ladder a greater distance.
Splicing:
Splicing kit contains:
2 splice joints, 8 screws, 1 ladder step with 2
bolts and 2 nuts.
Start by drilling two holes at the end of each of the units you are
splicing. Use the splice joints to see where to drill the holes.
Multiple locking/release pins:
The kit contains:
1 release unit, 3 screws and
1 pin.
In a building
with multiple stories,
each story can have a release
pin.
Cut the outer stringer where
y o u w a n t t o p l a c e t h e
release pin.
Place the release unit
with 2 holes
on the outside of the outer
stringer.
No
w drill 2 holes on the upper
part of the ladder for the
release pin.
The release unit is attached
using 2 screws.
Fasten 1 screw in the lowest
hole on the opposite side so
that the screw head faces into
the ladder.
.
At last, drill a hole for the
release pin appr. 3 cm below
the joint as shown in the picture.
Use a 4,5 mm drill bit.
Release unit
Hole for release pin
Ladder
www.
x1escape.com
X 1 E s c a p e · N i e l s J u e l s g a t e 3 , 3 2 6 3 L a r v i k , N o r w a y · T l f . : 3 3 11 1 5 6 0 · E m a i l : p o s t @ x 1 e s c a p e . c o m
Different ladder len
ghts
can be combined to make up one
complete unit. Splice the ladders as sho
wn in the picture to the
right.
www.foldoutladders.com - [email protected]
