FokusLabs RE-vibe, User Manual, Page: 4 / 8

SWITCHING MODES
Switch to programing mode by using the programming tool to press and HOLD the Action
Button for 10 seconds, then release. RE-vibe will give a long vibration,
and flash the red and blue lights, to indicate you are in programming mode.
TAP the Action Button to toggle through Modes 1-4. See chart below
for mode descriptions.
After you tap, RE-vibe will give a vibration signal to indicate which
mode you have set (one vibration for Mode 1, two vibrations for Mode 2,
etc.).
Note: Once you begin using RE-vibe, each mode will give a variety of
different vibration patterns for reminders. These different vibration patterns are to prevent
you from getting used to the reminders, and are not indications of which mode you are in.
Setting: Reminder Frequency:
Mode 1 - Mildly Distracted About every 10 mins.
Mode 2 - Moderately Distracted About every 7 mins.
Mode 3 - Significantly Distracted About every 5 mins.
Mode 4 - Homework Mode
After toggling through modes,
RE-vibe will go back to Mode 1 after
advancing through Mode 4.
About every 3 mins. After 15 minutes of work-
ing, RE-vibe will cue a break by flashing its’
lights. Lights will remain flashing during the 5
min. break, then turn off when it’s time to go
back to work.