volume
This rotary potentiometer sets the loudness volume of the
microphone connected to the INPUT connector (8) + (26).
(9)
(22)
gain
This recessed pot matches the input level of the EasyPort to
the output level of a wired microphone. You can only adjust
the gain control with the supplied small screwdriver so that
the control cannot be misadjusted inadvertently.
The gain control has been factory preset to a medium
position.
(16)
(21)
gain
This recessed pot matches the input level of the EasyPort to
the output level of a wireless microphone. You can only
adjust the gain control with the supplied small screwdriver so
that the control cannot be misadjusted inadvertently.
The gain control has been factory preset to a medium
position.
(17)
wireless receiver
(10) squelch, (11) channel
For details on the optional wireless receiver please refer to
the enclosed instruction manual for the receiver.
(10)
(11)
input
This balanced female XLR connector allows you to connect a
wired microphone (optional) via a standard microphone cable
with a male XLR connector (optional). Since the microphone
INPUT provides 12 V phantom power you can connect both
dynamic and electret or condenser microphones.
Input sensitivy for nominal level is 2 mV into 1 k
Ω
.
Pin 1 is ground, pin 2 „hot“ (inphase), pin 3 return.
(8)
(26)
volume
This rotary potentiometer sets the loudness volume of the
wireless microphone.
(12)
bass
Rotary control for cutting or boosting the low frequencies.
(13)
treble
Rotary control for cutting or boosting the high frequencies.
(14)
The two-band equalizer acts on the microphone inputs
only.
EQ
volume
This rotary potentiometer sets the loudness volume of the
audio source connected to the line input l/r jacks (5) + (23).
(6)
line out l/r
These two RCA jacks allow you to connect either a recorder
or another EasyPort to your unit using a stereo RCA cable
(not supplied).
The two jacks are internally paralleled and carry the output
signal of the built-in mixer with all the volume and EQ
settings you made. The output voltage at nominal level is 0,5
V into 200
Ω
source impedance.
(7)
gain
This recessed pot matches the input level of the EasyPort to
the output level of an external audio source. You can only
adjust the gain control with the supplied small screwdriver so
that the control cannot be misadjusted inadvertently.
The gain control has been factory preset to a medium
position.
(15)
line input
Line input, XLR electronically symmetrical, for playback
equipment or other signal sources
(Symmetry transformer optional).
(23)
line output jack
(24) mix out:
Line output, XLR symmetrical for passing on the complete
mixer signal to recording equipment or other EasyPort
systems (when switch is in the „mix-out“ position).
(24) receiver out:
Receiver out for ch4, XLR symmetrical, pre fade.
(when switch is in the „receiver-out“ position)
(25)
line input l/r
music
wired mic
wireless mic
These two RCA jacks allow you to conect a CD player,
cassette recorder, or other line level source to your EasyPort
using a stereo RCA cable (not supplied). The stereo input
signal is internally summed to mono.
Input sensitivity is 100 mV into 10 k
Ω
for nominal level.
(5)
Speakon output port for FP2
slave
(option)
Passive additional speaker
FP2
slave
can be connect to
FP2
pro/CD
with loadspeaker cable.
Note:
Only use
FP2
slave
on this output port!
(19)
13
