Pro AV 1600 User's Manual
9
2.1.0
Pro AV 1600 PCI Version
The Pro AV 1600 PCI is shipped with a Univiewer cable.
Follow these steps to install your Pro AV 1600 PCI. If you intend to use the Pro AV 1600 with Genlock or
component output please see Appendix C (Genlock operation) and Appendix D (Component output) for further
information on these features.
Hardware Installation
1. Turn the computer off.
2. Install the PCI card.
3. Disconnect the Computer Display from the Graphics Card on the Computer.
4. Connect the Univiewer module to the output of your computer graphics card. Connect the flying lead of the
Univiewer cable to the VGA input of the Pro AV PCI card..
5. Connect your Video Device to the Composite Video and/or S-Video output connector. (You may connect both
outputs simultaneously to the same or different Video Devices: Video is always available on both these outputs.)
6. Turn the computer on and run (or install) the Pro AV 1600 application software
7. From the application, set the Sync Selection to “IN= VGA SYNC”. (See section 3.1.19 for additional details on
Sync Selection.)
8. If everything is correctly installed, you will see your computer's normal power up sequence appearing on both the
Computer Display and the Video Device.
Software Installation
SYSTEM REQUIREMENTS:
Pentium-class system with an available 32-bit PCI slot.
Windows 98, ME, NT, or 2000
**********************************************************************
INSTALLATION PACKAGE:
ProAV.inf
ProAV.sys
ProAV.cpl
ReadMe.txt
Win98(Me) Destination directories:
ProAV.sys is copied to c:\windows\system32\drivers
ProAV.cpl is copied to c:\windows\system
Win2000 Destination directories:
ProAV.sys is copied to c:\winnt\system32\drivers
ProAV.cpl is copied to c:\winnt\system32
**********************************************************************
