13
ARRANGING THE CERAMIC FIRE-BED
Only the ceramics supplied with this appliance are to be used. The
ceramics must be laid only as shown on the following pages. Replacement
parts including mat are available from your dealer, but should only be
installed by a qualified installation engineer.
A. LOG ARRANGEMENTS - EMBERS
Place the Mat on top of the burner such that all the holes on the mat align
with the holes on the burner top plate.
Scatter the Embers over the top of the Mat and the Grate. Special care
must be taken not to let any embers enter the Pilot Shield and impinge on
the pilot or thermocouple.
When arranging the embers for LPG (shown above) the Gas Ports on top
of the burner must be left clear.
B. LOG ARRANGEMENTS - NATURAL GAS
Place the Large Log across the rear of the fire, as shown in the picture
below. This log should be placed such that it is only on top of the grate and
not sitting on top of the burner.
Place the remaining five logs as shown in the picture below, i.e. the logs
are placed so that one end of each log reaches to the front of the fire, and
the other end rests on top of the large log at the rear of the fire.
C. LOG ARRANGEMENTS - LPG GAS
Place the Large Log across the rear of the fire, as shown in the picture
below. This log should be placed such that it is only on top of the grate and
not sitting on top of the burner.
Place one of the brached logs on the rear of the burner such that it stands
up against the rear log, as shown in the picture below.
Now select the two straight logs, and place them on the fuel bed so that
they are placed one at each end of the burner.
Place the two remaining logs symetrically at the front of the burner so that
they curve around from the pilot shield to rest on the logs at the end of the
burner. The central holes on top of the burner should remain unblocked
by the Logs.
Installer section