M) Refit the upper support bracket along with the hinge cover.
As shown in Figure 22.
IMPORTANT: Check that both the upper and lower doors open and shut correctly without fouling after you have
completed the door reversal process.
After the door has been reversed, you should check the door seal of the fridge and freezer door. Neither seal should
be creased or crushed; otherwise there will be a gap between it and the inside of the door.
The seal must adhere properly all the way around the door.
If either seal is not adhering to the cabinet properly then you should either.
1.Use a warm damp cloth and manipulate the seal until it does adhere to the cabinet properly all the way around the door.
Or
2.Use a hair dryer on its lowest heat setting and lightly heat the areas of the door seal that are not adhering correctly. The heat will
make the seal more pliable and this will allow you to manipulate the seal into the correct position.
IMPORTANT: Only use the lowest setting of the hair dryer and do not heat the seal for long periods of time
otherwise irreversible damage may be caused and this will not be covered by your guarantee.
IMPORTANT: When you have reversed the doors of the appliance and if you have placed the appliance on its side,
you must wait for 8 hours before switching the appliance back on.
17
©
2013 Focal Point Fires plc.
8.3 REVERSING THE RD-270REU DOORS
- CONTINUED
GB IE
Figure 22
Figure 23
Figure 24
Downloaded from
www.Manualslib.com
manuals search engine
