Corner W
Wall LLocation:
The minimum distance from the top of the appliance to a ceiling is 700mm.
The minimum distance to the sides of the appliance is 100mm.
The minimum distance to the front of the applaince is 500mm.
The appliance can be wall mounted at floor level, providing it does not stand on a carpet or similar material.
Allow clearance to carpets of 30mm.
Note: tthe m
manufacturer ddoes nnot rrecommend ffitting aany sshelves aabove tthe aappliance w
when ccorner m
mounted.
UNPACKING TTHE A
APPLIANCE
Caution: TThis aappliance iis hheavy. A
Always sseek aassistance w
whilst uunpacking aand/or dduring iinstallation.
Read all the instructions before continuing to unpack or install this appliance. Carefully remove the appliance
from its packaging and lay on the floor with it`s back surface downward.
Note: DO NOT stand the appliance on its front frame as this may cause distortion.
Check that the remaining packaging contents correlate with the component checklist below. Please dispose of
all packaging with care at your local recycling centre.
COMPONENT C
CHECKLIST
QUANTITY
DESCRIPTION
1
Fire Appliance fitted with Decorative Frame and Corner Wall Bracket
1
Bag of Decorative Pebbles
1
Instruction Booklet
1
Screw Fixing Pack (6 x 37mm long round head screws and 6 plastic wall plugs)
1
Wall Mounting Template (for flat wall locations)
PREPARING TTHE A
APPLIANCE
CAUTION: D
DO N
NOT cconnect tthe aappliance tto tthe ssupply aat tthis
stage.
1. With the appliance laying on its rear surface, ie with the front
hinged door uppermost, carefully open the hinged door to its fully
open position.
2. Now remove the 2 x No 8 Phillips self tapping screws, retaining
the lower lamp cover plate, as shown in figure 1. Remove the cover
plate by sliding towards the top of the appliance and then easing
from its lower retaining slot.
3. Carefully “ease” the white fuel bed from the appliance as
shown in figure 2. Be careful not to damage the spinner or
lamp during removal.
This allows access to the lower fixing position of the rear cor-
ner bracket attached to the back of the main case assembly.
3
6.0
7.0
8.0
Fig 11
Fig 22
2 off screws
©
2007 Focal Point Fires plc.
