IMPORTANT NOTES
DO NOT use this appliance immediately below a fixed socket outlet.
DO NOT use this appliance in the immediate vicinity of a bath, shower, swimming pool or other area where water/moisture could present
a hazard.
• CAUTION: This appliance must not be used in conjunction with any timer, programmer or thermal control, or any other device that will
switch on the appliance automatically, as a fire risk may occur if the heater is accidentally covered or displaced.
• Do not allow the heater to be covered as this may cause overheating. The appliance must not be placed near curtains or similar materi-
al. A clearance space of at least one metre must be allowed in front of the appliance. A clearance space of 100mm each side must be
allowed. A clearance space of 50mm must be allowed for the back of the appliance.
• The electrical socket that the appliance uses MUST be easily accessible. Do not route the supply cord directly in front of the heater unit.
• If the cord is damaged, it must be replaced by a service agent or competent person.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the appliance.
INSTALLATION REQUIREMENTS
The appliance is supplied with a pre-wired three pin BS1363 plug plug (13Amp fuse rated) and 1.6 metres of electrical flex. It is therefore
necessary for a suitable electrical socket to be located within this distance of the appliance and be easily accessible. The stove may be
installed on a combustible or non-combustible floor, however the heater outlet is underneath the stove and certain types of floor covering
may be affected by the heat produced by the stove. The ability of the floor covering to withstand the heat produced by the stove should be
ascertained before proceeding with the installation of the stove. If in doubt then the stove should be mounted on a non-combustible hearth
or plinth which extends for at least 150mm in front of the stove.
This appliance should be positioned on a firm level surface. If the stove is to be sited in a fire surround then the suitability of the surround
for use with electrical heaters should be established with the fire surround manufacturer.
If fitted into an open draught fireplace, it is advisable to block off the chimney to reduce the risk of draught through the stove which may
cause the safety cut out system in the fan heater to operate.
UNPACKING THE APPLIANCE
Read
all the instructions before continuing to unpack or install this appliance. Carefully lift the appliance from the carton. Check that the
contents correlate with the component checklist below. Please dispose of all packaging with care at your local recycling centre.
COMPONENT CHECKLIST
QUANTITY
DESCRIPTION
1
Heater
1
User instruction booklet
1
Section
1.0
2.0
3.0
4.0
4.1
Contents
Important Notes
Appliance Data
Installation Requirements
Unpacking the Appliance
Component Checklist
Page No.
1
1
1
1
1
1
Section
5.0
5.1
6.0
7.0
8.0
9.0
Contents
Operating the Appliance
Safety Cutout System
Maintenance
Cleaning
Spares
Servicing
Page No.
2
2
2
2
2
1.0
2.0
3.0
4.0
4.1
APPLIANCE DATA
Supply Voltage :
230-240v~50Hz
Fuse Rating :
13 Amp
Heating Elements :
2 x 900W
Lighting :
2 x 25W E14 bulb
Location :
Indoor use only
Supply plug/cord :
BS1363/1.6 metres length
©
2008 Focal Point Fires plc.
