3
7.0 APPLIANCE DISASSEMBLY
GB IE
CAUTION: DO NOT CONNECT THE APPLIANCE TO THE ELECTRICAL SUPPLY AT THIS TIME.
Removing the decorative facia:
The Appliance is supplied with a decorative facia fitted. This must be removed before the
appliance can be wall mounted :
Andalusia models :
Simply lift off the frame. To re-fit, ensure the four mounting hooks engage the four corresponding holes
on the front of the appliance as shown in figure 1.
Kavachi, Piano, Valeria and Cascara models :
First, remove the retaining thumbscrews (one on each side of the appliance).
Simply lift the frame upwards. Refitting is the reverse of removal. Ensure the cut-outs in the bottom of the frame support brack-
ets engage the support pins on each side of the appliance.
Focal Point Fires plc. assumes absolutely no
responsibility for injuries and damages that
may occur due to improper installation or
handling. The appliance should not be installed
until all wet plastering and/or dry wall sand-
ing and wall painting has been completed. Do
not block the ventilation holes of the appli-
ance. The wall onto which the appliance is
installed must be flat. Install only on a vertical
surface. Avoid sloped surfaces. Installation
onto anything other than a vertical wall may
result in fire, damage or injury.
Marking Positions:
Having selected the final
mounting position for the appliance, taking into
account the site requirements as detailed
above, the fire can now be fixed to the wall.
There are three fixing positions, two upper
“hanging” positions, and one lower positions.
Refer to Fig 3 for details. The two upper posi-
tions are located 85mm down from the top
edge of the top frame, and are spaced 350mm
apart about the centre line of the appliance. Once these have been marked the lower fixing position
can then be marked. This is 395mm vertically below the upper fixing positions, on the appliance centre
line. See Fig 3. Use a spirit level to ensure that the upper positions are horizontally aligned.
Wall Fixings:
If the appliance is to be mounted on the inner leaf of a conventional cavity wall or a
solid wall, drill three holes to a depth of 42mm using a 8mm masonry bit. Insert the wall-plugs pro-
vided. If the appliance is to be mounted on a dry lined wall or timber framed construction, then spe-
cial cavity screw fixings will be required, that are not supplied with this product (see figure 4). Insert 2 x 40mm long fixing screws into
the upper two wall-plugs, taking care to leave the screws protruding approximately 6mm from the wall. Now hang the appliance onto
these upper screws through the two keyhole shaped holes in the upper brackets on the back panel of the appliance. Insert the lower
fixing screw into the lower wall plug through the corresponding fixing hole in the lower part of the back panel. Do not tighten fully.
Before tightening the wall mounting screws fully, at this stage it is recommended to check the horizontal alignment of the appliance
with a spirit level, as small adjustments can still be made if necessary. When this has been checked, tighten all four fixing screws fully.
To access the upper fixing screws insert a screwdriver through the access holes in the front face of the heater casing.
8.0 FIXING THE APPLIANCE
Figure 1
Figure 2
Andalusia frame mounting points
Kavachi, Piano, Valeria and Cascara models
1.Remove retaining
Thumbscrews
2.Lift frame away
from supporting pins
350mm
Lower fixing
point
Upper fixing points
C
L
395mm
Figure 3
©
2010 Focal Point Fires plc.
Figure 4
