APPLIANCE DISASSEMBLY:
CAUTION: DO NOT CONNECT THE APPLIANCE TO THE ELECTRICAL SUPPLY AT THIS TIME
Removing the decorative facia
The Appliance is supplied with a decorative facia fitted. This must be removed before the appliance can be wall mounted :
Andalusia models : Simply lift off the frame. To re-fit, ensure the four mounting hooks engage the four corresponding holes on the front of
the appliance as shown in figure 1.
Kavachi models : First, remove the retaining thumbscrews (one on each side of the appliance). Simply lift the frame upwards. Refitting is
the reverse of removal. Ensure the cut-outs in the bottom of the frame support brackets engage the support pins on each side of the appli-
ance.
FIXING THE
APPLIANCE:
Focal Point Fires plc. assumes
absolutely no responsibility for
injuries and damages that may occur
due to improper installation or han-
dling. The appliance should not be
installed until all wet plastering and/or
dry wall sanding and wall painting has
been completed. Do not block the
ventilation holes of the appliance. The
wall onto which the appliance is
installed must be flat. Install only on a
vertical surface. Avoid sloped sur-
faces. Installation onto anything other
than a vertical wall may result in fire,
damage or injury.
Marking Positions: Having selected
the final mounting position for the
appliance, taking into account the site
requirements as detailed above, the
fire can now be fixed to the wall.
There are three fixing positions, two
upper “hanging” positions, and one
lower positions. Refer to Fig 3 for
details. The two upper positions are
located 85mm down from the top
edge of the top frame, and are spaced 350mm apart about the centre line of the appliance. Once
these have been marked the lower fixing position can then be marked. This is 395mm vertically below
the upper fixing positions, on the appliance centre line. See Fig 3. Use a spirit level to ensure that the
upper positions are horizontally aligned.
Wall Fixings: If the appliance is to be mounted on the inner leaf of a conventional cavity wall or a solid
wall, drill three holes to a depth of 42mm using a 8mm masonry bit. Insert the wall-plugs provided. If
the appliance is to be mounted on a dry lined wall or timber framed construction, then special cavi-
ty screw fixings will be required, that are not supplied with this product (see figure 4). Insert 2 x 40mm long fixing screws into the upper
two wall-plugs, taking care to leave the screws protruding approximately 6mm from the wall. Now hang the appliance onto these upper
screws through the two keyhole shaped holes in the upper brackets on the back panel of the appliance.
Insert the lower fixing screw into the lower wall plug through the corresponding fixing hole in the lower part of the back panel. Do not tight-
en fully. Before tightening the wall mounting screws fully, at this stage it is recommended to check the horizontal alignment of the appli-
ance with a spirit level, as small adjustments can still be made if necessary. When this has been checked, tighten all four fixing screws fully.
To access the upper fixing screws insert a screwdriver through the access holes in the front face of the heater casing.
2
7.0
8.0
‘Andalusia’ frame mounting points
‘Kavachi’ models
1.Remove retaining
Thumbscrews
Figure 1
Figure 2
350mm
Lower fixing
point
Upper fixing points
C
L
395mm
Figure 3
Figure 4
2.Lift frame away
from supporting pins
