FIXING THE APPLIANCE
A) Marking Positions:
Having selected the final mounting position for the appliance, taking into account the site requirements as
detailed in section 4, the heater can now be fixed to the wall.
There are three fixing positions, two upper “hanging” positions”, and one lower position on the backpanel locat-
ed behind the fuel bed. Refer to Fig 4 for details.
A template is provided to aid location of fixings. Use a spirit level to ensure that the template is level. This ensures
that both upper and lower fixing positions are horizontally aligned.
Using the template in the required position on the wall, “mark through” the template and onto the wall at the
three mounting locations designated “P23E” for this particular appliance. Now remove the template.
B) Wall Fixings:
If the appliance is to be mounted on the inner leaf of a conventional cavity wall or a solid wall, drill three holes
to a depth of 42mm using only a 8mm masonry bit.
Insert the wall-plugs provided. If the appliance is to be mounted on a dry lined wall or timber framed construc-
tion, then special cavity screw fixings will be required, that are not supplied with this product. Insert 2 x 37mm
long fixing screws into the upper two wall-plugs, taking care to leave the screws protruding approximately 6mm
from the wall.
The appliance can now be “hung” onto the two upper wall fixings, ensuring that the heads of the screws go
through the keyhole shaped holes, and then drop down into the slot.
Ensure that the lower rear panel fixing hole aligns with the wall plug, and then insert 1 x 37mm fixing screw and
fully tighten.
Finally fully tighten the two upper fixing screws, through the two panel acess holes at the front of the appliance.
C) Re-Assembly of Appliance:
Note: re-assembly is the reverse of disassembly as described in section 8.0
1. Refit the fuel bed, ensuring that the lamp spinner is free to rotate.
2. Refit the lower lamp cover plate, firstly inserting the bottom edge behind the firebox lip. Secure with the two
screws previously removed.
Peel off any remaining protective plastic coatings on the front frame, curved backpanel and the plastic fuel bed.
3. Unpack the pebbles and arrange them over the fuel bed. The
final pebble arrangement can only be done later when the lamp is
switched on and light shines up through the transparent cover.
The ideal pebble layout is shown in the photograph on the right.
4. Reattach the front decorative frame by hanging onto the two
upper fixing bolts, and reinserting the two lower fixing bolts
through the lower fixing brackets. Retighten the two lower fixing
bolts.
Note: For Trinity models either the chrome or brass decorative
trim pieces can be attached. Use the the supplied magnets equal-
ly spaced along the rear face of each trim section. Fit both side
sections firstly, followed by the top and bottom sections.
4
9.0
