UNPACKING THE APPLIANCE
Caution: This appliance is heavy. Always seek assistance whilst unpacking and/or during installation.
Read
all the instructions before continuing to unpack or install this appliance. Carefully remove the appliance
from its packaging and lay on the floor with it`s back surface downward.
Note: DO NOT stand the appliance on its front frame as this may cause distortion.
Check that the remaining packaging contents correlate with the component checklist below. Please dispose of
all packaging with care at your local recycling centre.
COMPONENT CHECKLIST
QUANTITY DESCRIPTION
1
Fire Appliance
1
Decorative Frame (Monet models only)
1
Decorative Frame Decorative frame edge sets and attachment magnets (Trinity models only)
1
Decorative glass facia (Ebony models only)
1
Bag of Decorative Pebbles
1
Instruction Booklet
3
37mm Pozi Pan-Head Screws
3 Wall
plugs
1
Wall Mounting Template
PREPARING THE APPLIANCE
DO NOT connect the appliance to the supply at this stage.
1. Carefully remove the front decorative frame from the main casing by unscrewing and
removing the 2 lower M6 thumbscrews, (2 located on either side), as
shown in Fig 2.
Lift the frame vertically upwards to clear the upper two thumbscrews and
pull gently forwards to release from the main case assembly.
Now remove the 2 x No 8 Pozi self tapping
screws, retaining the lower lamp cover plate,
as shown in Fig 3, and remove the cover
plate.
3. Carefully “ease” the white fuel bed from the appliance.
This allows access to the lower fixing position located at the back of
the main case assembly. See Fig 4.
3
6.0
7.0
Fig 2
Fig 3
No 8 fixing
screws
Lamp cover
plate
Fig 4
Lower fixing
position
Lower
Fixings
Upper
Fixings
8.0
Monet model illustrated
