Coal effect models
1. Position the combustion matrix onto the burner tray as shown in
figure 8. The front edge of the matrix should sit snugly behind the
back edge of the burner rails as shown in figure 7. Do not fit the
matrix on top of the burner rails.
2. Position the front coal strip as shown in figure 9. The rear edge of
the front coal strip should fit in front of the burner rail. Again, do not
to place on top of the burner rails. When the front coal is in posi-
tion bend up the three
metal tabs at the front of
the tray to retain as
shown in figure 10.
3. Coals. All of the coals are the same. Take five coals and place them
as shown in figure 11. Care should be taken to ensure that the coals
bridge the gap between the front coal and the four coal supports at
the front of the matrix. Care should also be taken not to push the
coals right down between the coal supports, as this can detract from
the flame picture when the appliance is running.
4. Take five more moulded coals and position as shown in figure 12
to form the ‘second row’ of the fuel effect. The coals may be rotated
as desired to fit into the gaps between the coal supports in order to
create a random, realistic effect. Again, remember not to push the
coals down too far into the valleys between the coal supports as this
can have a detrimental effect to the flame picture
Figure 8
Figure 7
Correct
Incorrect
Figure 9
7.0 FUEL BED LAYOUT - COAL EFFECT
GB IE
4
© 2013 Focal Point Fires plc.
Figure 11
Figure 10
Figure 12
