11
e) Test fit the wing halves together on the dihedral braces. If the airfoil has
been rolled correctly, the centers should fit flush with each other. Glue
the wings one half at a time to the center assembly, using the ridge at
the center of the dihedral braces to help position the wing correctly. Be
sure the glue the wing halves to each other at the same time.
4) Motor
Pylon:
a) You might want to cut a notch in the two center sections of the pylon to
pass the motor wire through. When assembling the Motor Pylon be
sure to align the pieces by either the motor cutout, or the top side. The
bottom sides are deliberately offset to fit into the dihedral of the wings.
Glue the four sections together. Test fit the motor stick into the pylon.
Make sure that the motor stick fits tight against the top of its slot. This
will product the correct thrust angle.
b) There is a small lip on the underside of the pylon near the front. This
tiny ridge will hang over the front edge of the wing, and is to be used for
alignment. The pylon should be centered on the wing, and place
forward to back using the lip to find the correct position. Once you get
the pylon in position, make a hole in the wing directly under the hole in
the pylon, for the motor wire to pass through, and then glue the pylon in
place.
