![FNM HPE 300 Owner'S Manual Download Page 24](http://html1.mh-extra.com/html/fnm/hpe-300/hpe-300_owners-manual_2313271024.webp)
Marine Diesel Engines
O
WNER
’
S
M
ANUAL
General Information
HPE 300
ENG rel. 1/11
www.fnm-marine.com
24
-
Disconnect the electrical connections. Push the red stop button on the ECU box .
-
Clean the engine metal part and spray the engine metal parts and the engine leverages with a
protective/unlocking spray to prevent rust. FNM
®
advises to use Bardahl
®
K9 spray
.
-
Grease the starter pinion and the mechanical connections (grooved joints, etc.)
-
Dismount the belts and store them preventing their deformation.
-
Disconnect the fuel line (inlet and outlet).
-
Spray the electrical connections with electrical connections protective spray.
-
Store the engine in a well aerated place avoiding humidity and steam to prevent rust forming.
-
For long storage of fuel in tank, FNM® advises to use Bardahl® DAB additive or IOSSO® Diesel
fuel antibacterial to prevent the proliferation of algae and deposits.
-
For fuel winter storage, FNM
®
advises (for very cold storage) to use diesel fuel antifreeze additive.
FNM® advises use of Bardahl Diesel Antifreeze
.
ATTENTION!
Take care of the engine storage room out of the boat or maintain the boat engine room dry and free from
salt vapor.
-
After a period of inactivity, it is necessary to carry out few maintenance interventions before
starting the engine again to ensure its efficiency and duration.
-
Verify the battery charge level conditions. Make sure that the battery voltage is greater than 12
Volt.
-
-Make sure that the electric contacts are intact and properly grease with basic grease. Assure the
correct electrical connections.
-
Carry out the engine electronic diagnosis at the first starting after a long period of inactivity.
-
-Check the oil level conditions, and if necessary, top up or replace with synthetic oil SAE 5 W 40
as advised.
-
Verify the clogging level and if necessary replace the oil filter.
-
Check the coolant level and if necessary top up. Drain the sea water circuits.
-
Verify and if necessary replace/clean the fuel filter.
-
Clean the air filter.
-
Verify the belts and tighteners status.
-
Verify the integrity of the sea water pump impeller.
Summary of Contents for HPE 300
Page 1: ...OWNER S MANUAL HPE 300...
Page 78: ...www fnm marine com...