Instructions to the OEM/Integrator:
This module has been granted modular approval for mobile applications. OEM integrators for host
products may use the module in their final products without additional FCC/ISED (Innovation,
Science and Economic Development Canada) certification if they meet the following conditions.
Otherwise, Additional FCC/IC approvals must be obtained.
The OEM must comply with the FCC labeling requirements. If the module’s label is not visible
when installed, then an additional permanent label must be applied on the outside of the
finished product which states: ”Contains transmitter module FCC ID: 2ASV9-
6189N
”.
Additionally, the following statement should be included on the
label and in the final
product’s user manual:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interferences, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.”
The user’s manual for the host product must clearly indicate the operating requirements
and conditions that must be observed to ensure compliance with current FCC / IC RF exposure
guidelines.
The final host / module combination may also need to be evaluated against the FCC Part 15B
criteria for unintentional radiators in order to be properly authorized for operation as
a Part 15 digital device.
This Module is full modular approval, it is limited to OEM installation ONLY.
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module.
The Grantee will provide guidance to the Host Manufacturer for compliance with the Part
15B requirements if requested.
Any modifications made to the module will void the Grant of certification ,including
antenna replacement ,the OEM integrator will be responsible for re-evaluating
radiated
emission of part 15C,and obtain a separate FCC authorization.
IC labeling requirement for the final end product:
The final end product must be labeled in a visible area with the following “Contains IC:
24909-8188U1PS”
The Host Marketing Name (HMN) must be indicated at any location on the exterior of the host
product or product packaging or product literature, which shall be available with the host
product or online.
Le produit final doit être noté dans une zone visible “Contains IC: 24909-
6189N
”
Le nom du présentateur (HMN) doit être indiqué dans toute location sur le nom du produit hôte
ou du label ou de la littérature du produit,
Qui doit être disponible avec le produit hôte ou en ligne.
