3131A-S
FN-LINK TECHNOLOGY LIMITED
19
Proprietary & Confidential Information
Warning:
Changes or modifications to this unit not expressly approved by the part responsible
for compliance could void the user’s authority to operate the equipment.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following "Contains TX FCC
ID:" 2AATL-3131A-S", and the FCC part 15.19 statement has to be available on the label: This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
If the end product is so small or for such use that it is not practicable to place the statement
specified, the statement shall be placed in a prominent location in the instruction manual or
pamphlet supplied to the user or, alternatively, shall be placed on the container in which the
device is marketed.
The module must in the end-product be installed in such manner that the authorized antennas
can be used, any change of the antenna will void the certification.
Note:The module is limited to OEM installation ONLY;The OEM integrator is responsible
for ensuring that the end-user has no manual instructions to remove or install module.
This product is mounted inside of the end product only by professional installers OEM.
They use this module with changing the power and control signal setting by software
of end product within the scope of this application. End user can not change this
setting.
The equipment complies with RF exposure limits. This module is limited to installation
in mobile or fixed applications. The antenna used for this transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
