background image

13

EN

Trouble shooting

Problem

Possible Cause

Solution

Aircraft will not respond to 

the throttlebut responds to 

other controls.

-ESC is not armed.

-Throttle channel is reversed.

-Lower throttle stick and throttle trim to lowest  settings.

-Reverse throttle channel on transmitter.

Extra propeller noise or 

extra vibration.

-Damaged spinner, propeller,

 motor or motor mount.

-Loose propeller and spinner parts.

-Propellor installed backwards.

-Replace damaged parts.

-Tighten parts for propeller adapter, propeller and spinner.

-Remove and install propeller correctly.

Reduced flight time or 

aircraft underpowered.

-Flight battery charge is low.

-propeller installed backward.

-Flight battery damaged.

-Completely recharge flight battery.

-Replace flight battery and follow flight battery 

 instructions.

Control surface does not 

move, or is slow to respond 

to control inputs.

-Control surface, control horn,

 linkage or servo damage.

-Wire damaged or connections 

 loose.

-Replace or repair damaged parts and adjust controls.

-Do a check of connections for loose wiring.

Controls reversed.

Channels are reversed in the 

transmitter.

Do the control direction test and adjust controls for 

aircraft and transmitter.

-Motor loses power

-Motor power pulses then 

 motor loses power.

-Damage to motor, or battery.

-Loss of power to aircraft.

-ESC uses default soft Low Voltage

 Cutoff(LVC).

-Do a check of batteries, transmitter, receiver, ESC, motor 

 and wiring for damage(replace as needed).

-Land aircraft immediately and recharge flight battery.

LED on receiver flashes 

slowly.

Power loss to receiver.

-Check connection from ESC to receiver.

-Check servos for damage.

-Check linkages for binding.

Spare parts list content

FMSRY101

FMSRY102

FMSRY103

FMSRY104

FMSRY105

FMSRY106

FMSRY107

FMSRY108

FMSRY109

FMSRY110

FMSRY111

FMSRY112

FMSRY113

FMSRY114

FMSRY115

Fuselage

Main Wing Set(top)

Main Wing Set(lower)

Vertical Stabilizer

Horizontal Stabilizer

Canopy

Canopy

Cowl

Front Landing Gear Set

Front Landing Gear Mounting Plate

Interplane Strut

Cabane

Spinner

Inclined Stay Bar

Rear landing Gear Assembly

FMSRY116

FMSRY117

FMSRY118

FMSRY119

FMSRY120

FMSPROP035

FMSBM003

FMSDZ005

FMSDJ014

PRKV460E

PRESC033

FMS17GAP

Linkage Rod

Screws Set

Stickers

Pipe

Battery Tray

Propeller

Motor Board

Motor Shaft

Motor Mount

4258-KV460 motor

50A ESC with 5A BEC

17g analog gear servo positive

Visit our website: www.fmsmodel.com to see photo of this product. Enter the key word "ESC" in the search bar for the 

stock ESC instruction manual.

Summary of Contents for Pitts 1400 mm














Reviews: