www.fmiproducts.com
55511F
4
FireBox inSTALLATion
Figure 2 - Common Location of Fireplace
MINIMUM CLEARANCE TO
COMBUSTIBLES
Back and sides of firebox
1" min.
Adjacent wall
12" min.
Chimney outer pipe surfaces 2" min.
Bottom of firebox to floor
0" min.
WARNING: Do not block
required air spaces with insu-
lation or any other material.
Do not obstruct effective open-
ing* of firebox with any type of
facing material. Combustible
material must not be in contact
with black front face of firebox.
*
(The effective opening is considered
the opening where actual heat output
may occur.)
MANTEL CLEARANCES
Woodwork such as wood trims, mantels or
any other combustible material projecting from
the front face must not be placed within 9" of
firebox effective opening.
Combustible materials above and projecting
more than 1
1
/
2
" from the firebox front face
(see Figure 4, page 5) must not be placed less
than 12" from effective opening of the firebox
(NFPA STD 211, Sec. 7-3.3.3).
Mantels or any other combustible material
may also come up to the side edge of the
black metal face of the firebox only if the
projection from the front face falls within limits
shown in Figure 5, page 5.
Spacers on Sides of
Fireplace Provide
Required 1" (2.5cm)
Clearance
2" (5cm) Min. Clearance
From Pipe to
Combustibles
3" (7.6cm)
12" (30.4cm) Min. From Perpendicular
Side Wall to Fireplace Opening (Typ.)
Figure 3 - Firebox Clearances
Existing Wall
Projected Wall
12" (30.4 cm) to
Perpendicular Wall
SELECTING LOCATION
To determine the safest and most efficient
location for the firebox, you must take into
consideration the following guidelines:
1. The location must allow for proper clear-
ances.
2. Consider a location where the heat output
will not be affected by drafts, air condition-
ing ducts, windows or doors.
3. A location that avoids the cutting of
joists or roof rafters will make installation
easier.
4. If an outside air kit is to be installed, ac-
cessibility to outside combustion air must
be considered. This can also be achieved
through a vented crawl space in some
cases (see
Optional Outside Air Kit
on
page 6).
5. Do not connect this firebox to a chimney
system other than a FMI PRODUCTS,
LLC chimney system.
6. Install in an area providing ventilation and
adequate combustion air.
7. Due to high temperatures, do not locate
this firebox in high traffic areas or near
furniture or draperies.
8. Provide adequate clearances around
air openings into combustion chamber.
NEVER obstruct front opening of firebox
or flow of combustion and ventilation air.
9. Do not locate in or near an area where
gasoline or other flammable liquids may
be stored. The firebox area must be kept
clear and free from these combustible
materials.
The typical installation for this fireplace is a
projected installation which allows you to ex-
tend the fireplace any distance into the room.
A projection may be ideal for a new addition
on an existing, finished wall.
