www.fmiproducts.com
125527-01E
22
INSTALLATION
Continued
Figure 34 - Installing Middle Log
Figure 35 - Installing Rear Left Top Log
and Rear Right Top Log
Figure 36 - Installing Ember Logs
Middle
Log
Ramp Log
Rear Left
Top Log
Rear Right
Top Log
Metal Pins
Left Ember Log
Right Ember Log
8. Place the rear left top log on top of the
middle log and the rear log. Match the
pin on the middle log with the round hole
in the bottom of the rear left top log (see
Figure 35. The rear log has a flat area for
the back of the rear left top log to set in.
9. Place the rear right top log on top of the
middle log and the rear log. Match the pin
on the middle log with the round hole in
the bottom of the rear right top log (see
Figure 35). The rear log has a flat area for
the back of the rear right top log to set in.
10. Place the left and right ember logs as
shown in Figure 36. Do not place the logs
on the ember bed pan they are intended
to cover the sheet metal on the front of
the base assembly.
CONCRETE LOG MODELS LBG
(18,24,30) BM
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Before placing any logs on the chassis you
will need to remove the Air Shield located
on the left side near the rear burner as
shown in Figure 37. The Air Shield is held
in place with one screw, remove the Air
Shield and place the screw back into the
hole in the chassis. Place the Air Shield
with you owner's manual and keep.
Figure 37 - Removing Air Shield
Air Shield
Screw
2. Place fiber ramp log in center of chassis
as shown in Figure 38, page 23. The fiber
ramp log can be identified by the shape
and much lighter weight when compared
to the other logs. The log must sit flat on
the black sheet metal and behind the left
metal tab as shown. Make sure the side
marked ''BOTTOM'' is setting down.
f i r e - p a r t s . c o m
