FMI DVFH34, Owner'S Operation And Installation Manual

Page: 21 / 40

21 106394
OWNER’S MANUAL
FIREPLACE
INSTALLATION
Continued
Installing Remote Receiver
1. Open bottom louver and locate the
switch bracket on the left.
2. Unscrew the switch bracket. Lean
bracket forward so you are able to ac-
cess the back of the remote receiver.
3. Locate the battery clip mounted on the
back of the receiver. Slide a 9-volt al-
kaline battery (not included) through
the clip (see Figure 39).
4. Attach the terminal wires to the battery.
5. Remove wire from TH to TPTH on
control valve (see Figure 40).
6. Connect wires from receiver to TH and
TPTH to control valve (see Figure 41).
7. Replace the switch bracket.
Figure 39 - Attaching Alkaline Battery to
Receiver
Installing 9-Volt Alkaline Battery
in Hand-Held Remote Control
Unit
1. Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to a 9-volt alka-
line battery (not included). Place bat-
tery into the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Figure 42 - Installing Alkaline Battery in
Hand-Held Remote Control Unit
Battery
Cover
9-Volt
Alkaline
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Figure 41 - Control Valve Terminals
To
Optional
Remote
Accessory
Figure 40 - Disconnecting TH to TPTH
Wire
9-Volt Alkaline
Battery
Receiver
Terminal
Wires
Battery Clip
INSTALLING OPTIONAL
WIRELESS HAND-HELD
REMOTE CONTROL - GHRC
SERIES/GHRCT SERIES
NOTICE: Use only alkaline bat-
teries (not included).
Continued
INSTALLING OPTIONAL
WALL MOUNTED
THERMOSTAT - GWMT1
WARNING: Installation must
be done by a qualified installer
familiar with low voltage wiring
procedures.
WARNING: Do not connect
this thermostat to any electrical
source! Electrical shock and/or
fire hazard will occur.
NOTICE: The GWMT1 includes 25'
of wire for installation. Your fire-
place includes 15' of wire for ac-
cessory installation. Choose the
length that best fits your needs
when installing this accessory.
1. Open lower louver panel. The valve is
attached to the underside of the fire-
box assembly.
2. Disconnect the wire that runs from TH
to TPTH from the valve as shown in
Figure 40.
3. Connect one terminal of the provided
wire for the wall thermostat to the TPTH
terminal on the valve. Connect remain-
ing wire terminal to the TH terminal on
the valve. Make sure that the wire termi-
nals are in the positions on the unit as
pictured in Figure 44. If wires are not
connected as shown the thermostat will
not work.
Figure 43 - Installing Battery in Hand-Held
Remote Control Unit (GHRCTA Series
Only)
Remote
Control
Unit
t
Figure 44 - Control Valve Terminals
To Wall Optional
Remote Accessory