www.fmiproducts.com
124972-01C
5
PRODUCT IDENTIFICATION
Figure 1 - Product Identification
Log Set
Control
Knob
Base Assembly
Ignitor
Rear Burner
Flame Adjustment Knob
Remote Control
(Optional)
OPTIONAL REMOTE CONTROL ACCESSORIES
LOCAL CODES
State of Massachusetts:
The installa-
tion must be made by a licensed plumber
or gas fitter in the Commonwealth of
Massachusetts.
Sellers of unvented propane or natural
gas-fired supplemental room heaters shall
provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
Vent-free gas products are prohibited for
bedroom and bathroom installation in the
Commonwealth of Massachusetts.
UNPACKING
CAUTION: Do not remove the
data plates from the grate as
-
sembly. The data plates contain
important warranty and safety
information.
1. Remove logs and heater base assembly
from carton.
Note: Do not pick up heater base assem-
bly by burners. This could damage heater.
Always handle base assembly by grate.
2. Remove all protective packaging applied
to logs and heater for shipment.
3. Check heater for any shipping damage. If
heater is damaged call FMI PRODUCTS,
LLC at 1-866-328-4537. Please do not
return it to the store.
Install and use heater with care. Follow all
local codes. In the absence of local codes,
use the latest edition of
The National Fuel
Gas Code, ANSI Z223.1/NFPA 54
*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
There are four optional remote controls that
can be purchased separately for Remote-
Ready Models Only:
• wall switch
•
hand-held ON/OFF remote
•
wall thermostat
• hand-held thermostat remote
See
Accessories
, page 37.
The wall thermostat or hand-held thermostat
may not be used where vented decorative
listing is required.
