www.fmiproducts.com
121308-01F
23
OPERATION
Continued
FLAME HEIGHT
This function allows you to control the height
of the flames through 5 levels. Select manual
flame height function by pressing MODE but
-
ton until a flame is shown in lower left corner
of display. Use the UP/DOWN arrow button
to set desired flame height (see Figure 37,
page 22). A beep from the receiver confirms
the command.
ON
ON
MAX
Figure 38 - Remote Control Display of
Flame Height Minimum and Maximum
MINIMUM
MAXIMUM
ROOM THERMOSTAT
The remote control can operate as a room
thermostat. The thermostat can be set to a
desired temperature to control the comfort
level in the room.
To activate, press THERMOSTAT button on
remote control (see Figure 37, page 22). The
word ON will appear to the right of temperature
bulb graphic on display (see Figure 39). Use
UP/DOWN arrow button to set desired room
temperature. Control system will cycle fireplace
on or off to maintain selected temperature.
ON
Figure 39 - Room Temperature Setting
Room
Temperature
Set
Temperature
SMART THERMOSTAT
The Smart Thermostat adjusts flame height
in accordance to differences between set
temperature and room temperature. As room
temperature gets closer to set temperature the
smart function will modulate the flame lower.
As room temperature cools, it will modulate
the flame higher.
SMART
MAX
Figure 40 - Smart Thermostat Setting
To activate this function, press THERMOSTAT
button until the word SMART appears to the
right of temperature bulb graphic on display.
Use UP/DOWN arrow button to set desired
room temperature. The control system will
cycle the fireplace on or off to maintain se
-
lected temperature.
ON
Figure 41 - Child Safety Lock-Out
CHILD SAFETY LOCK-OUT
This function lets you deactivate the remote
control buttons. It is active when the lock icon
is lit on the display.
To activate, press MODE button and UP ar
-
row button at the same time. To deactivate,
press again.
PROGRAMMING HAND-HELD REMOTE
CONTROL TO RECEIvER
If your remote ever needs to be replaced you
will not need to replace the receiver.
To program receiver with a new hand-held
remote, insert a small pin or paper clip into
hole on receiver face plate marked PRG. The
receiver will beep 3 times to indicate it is ready
to accept a new remote transmitter. Press
the ON/OFF button on your remote and the
receiver will beep 4 times to confirm it receives
commands from the new remote.
ON REMOTE OFF
PRG
To Program Receiver
Figure 42 - Programing Remote Control
to Receiver
