background image

For more information, visit www.fmiproducts.com

C32CO Corner Mantel and Base

 

ASSEMBLY AND INSTALLATION INSTRUCTIONS 

IMPORTANT: Read entire instruction sheet be-

fore assembling or installing mantel kit.
These mantels are only approved for use with 

any FMI PRODUCTS, LLC 32'' electric and gas 

fireplace systems. Do not use mantel with any 

other product.

•  This mantel kit contains the following:

#1 Base

#2 Right Side Assembly

#3 Left Side Assembly

#4 Header

#5 Top

#6 Top Triangle

#7 Top Left Support

#8 Top Right Support

#9 Top Center Support

#10 Base Support

#11 Vertical Support

Right Top Trim Strip

Left Top Trim Strip

•  Hardware Package

36 - 1 1/4" Wood Screws                                114325-01

8 - 1" Finishing Nails                                       114295-04

4 - 2" Wood Screws                                        122447-01 

* Extra hardware may be included

Tools required:

•  Power Screwdriver with #2 Phillips Bit

•  Hammer

•  Nail Set

If any wood pieces are missing or damaged, contact the dealer 

where you purchased this mantel for replacement. If hardware 

is  missing  or  damaged,  contact  FMI  PRODUCTS,  LLC  at 

1-866-328-4537  for  referral  information. You  can  also  visit 

FMI PRODUCTS, LLC’s web site at 

www.fmiproducts.com

.

Note: Gather all mantel pieces together before assembling 

mantel.

 

WARNING: Only use 1 1/4" screws to as-

semble mantel. Damage to mantel will result if 

other screws are used for this purpose.

Summary of Contents for C32CO

Page 1: ...Base Support 11 Vertical Support Right Top Trim Strip Left Top Trim Strip Hardware Package 36 1 1 4 Wood Screws 114325 01 8 1 Finishing Nails 114295 04 4 2 Wood Screws 122447 01 Extra hardware may be included Tools required Power Screwdriver with 2 Phillips Bit Hammer Nail Set Ifanywoodpiecesaremissingordamaged contactthedealer whereyoupurchasedthismantelforreplacement Ifhardware is missing or dam...

Page 2: ... Screws Base Support 10 Base 1 IMPORTANT Alignmantellefttorightonbasebeforeinstalling Corner of mantel legs must be flush with back of mantel base before installation see Figure 5 page 3 Use a tape measure to insure accuracy IMPORTANT Use2 screwsonlyontopcentersupport Using 2 screws in any other location will damage mantel Header 4 Right Leg Assembly 2 Left Leg Assembly 3 1 Screws Header into Groo...

Page 3: ...scratch easily Make sure fireplace is in proper position within mantel opening before continuing with installation 6 Gas fireplace with louver door Lower bottom louver door Use two screws provided in fireplace hardware kit and attach fireplace to wooden base Close louver door Gas fireplace with fixed louver Before installing logs or burner assembly see owner s manual remove screws securing floor t...

Page 4: ...d base into position in corner and flush against both walls Check operation of fireplace before proceeding 2 Place right trim strip on right side of top and left trim on left side of top Align both pieces so any gaps between mantel and wall are covered as well as possible and front of trim strips are flush with side of top With one person holding trim strips in place nail each strip to mantle usin...

Reviews: